FT1000MP & MarkV
The simple and safe RS232 CAT interface for Yaesu FT-1000MP
series of radios.
After having designed and built the interface for my Kenwood TS850S (see
SSK232), it was needed to design and build (quickly...) a safe interface for our
brand new Yaesu FT1000MP Mark V. This radio has a standard RS232C CAT interface
and it is ready to be connected with a PC but, as usual, I don't like to connect
the radio to a PC directly, without electrical separation, especially when is to
be used in "rude" RF environment like in a contest station.
The interface is similar to the one for the TS850S, but, in this case, I choose
two single, easy to find, optocouplers model 4N25. I take the power for the
radio side from the 13.8V connector of the FT1000, because there are no control
signals to use on the CAT DB9 connector (only TXD, RXD and GND are connected).
To power the circuit on the PC side, I use the DTR and RTS signals of the PC:
with all the software I tested, these pins are at +12V. I built it using the
ugly construction on a little un-etched piece of copper-clad circuit board that
fit in a very little plastic box. If you want, you can use one double
optocoupler TLP504A or CNY74-2.
With 200W, my interface doesn’t need any filter (capacitor and/or inductor), let
me know if you have RFI problems and I will suggest some filtering. The
interface is tested and perfectly working at 4800 baud with CT9, Writelog and
Easylog; I think that it will work with any software that don't needs the
handshake to the radio with RTS and CTS.
My "radio" PC is a P200MMX on an ASUS TX97E motherboard but the interface worked
fine also connected to the "main" PC, a PIII 933MHz (Intel 815 chipset) and a
P133 Notebook using two 2m long shielded serial cables.
Guido, ik2bcp / iu2r / ab9dg
You can download this schematic with better quality as a PDF file:
Yaesu OptoCAT by IK2BCP.pdf
Any question and/or comment to ik2bcp AT
This site was last updated